Page 1 2

Removing 1/8" Twist in very curly maple

Glueing up 3/16" venier, cut on bandsaw, to the face of the twisted board. Twist is 1/8".	Need to remove excess venier and square up the edge	Table Saw Jointing Sled is perfect for this job
Modified feather to rest it against the sled	Jointing the edge, while removing excess venier	Locating the pressure point where board is flat.
Marking "X" on the pressure points	Scribble witness marks all over the face	Reading results of first pass over the blades, stock removal is were expected, thus pressure points are good control
2nd pass continuing to be under control	All witness marks gone, its flat	Continue jointing until venier low spot, on left, is removed